1- Try to keep the same relative alligator clip position during coil measurement.
2- Electrical wires with alligator clips from Radio Shack?
3- The probe end is a copper alligator clip covered with a protective rubber boot.
4- The antenna and diode connection may be made with alligator clips for easy experimentation.
5- Gonecustomer thisnot only only dampening againright cheap alligator clips away.
6- Used an alligator clip to hold it against the host until the adhesive dried.
7- The video shows mine connected to a variable dc bench power supply with alligator clips .
8- Power for these models may come from standard 12-volt alligator clips or alkaline batteries.
9- Most run off 12-volt systems, with alligator clips attached to battery posts for power.
10- The conductive hand-tied squares will be connected to a MaKey MaKey with alligator clips .
11- Place the red alligator clip from the sprayer on the positive (+) battery post.
12- Clip the black alligator clip from the sprayer on the negative (-) battery post.
13- The lamé is connected to the body cord with an alligator clip causing it to be conductive.
14- alligator clips can be fiddly .
15- If you are able to find longer clips, five alligator clips would also work for this project.
16- I keep a "zip cord" handy, somewhere, with insulated alligator clips and a standard 110 male plug.
17- I attached them to a separate board and used wires with alligator clips to run the power back to the amp.
18- Buy alligator clips at a store like Frys Electronics or Radio Shack and use that to connect the foil to a ground.
19- Essentially a mini Copperhead (q.v.), its name comes from the orange and black striped tape strip provided to allow it to be used with ordinary alligator clip ignition systems.
20- It normally requires a special clip for electrical connections, but some rocketeers have mastered the "Z-Fold" which allows use of normal alligator clips .
21- In fact, one of the photos accompanying the article shows two alligator clips attached to a small cloth rectangle onto which a circuit board has been printed.
22- The main board was then temporarily soldered in and tested. (Some connections were made via alligator clips such as the speaker wires).
23- This is much more a factor when assembling metal models but some care does need to be taken as the alligator clips are usually pretty strong and can mar the soft metals.
24- The EMG electrodes should not be the kind that use alligator clips to attach to foil, because the head moves around during the VEMP.
25-
Learning Games for Fun :
Here are some games designed for not only learning but also having fun. Enjoy it now!
